11.2.4 Procedure for Writing Multiple Programs
This section describes a procedure for writing multiple programs to the program memory. (
Follow the procedure below and then the procedure provided in Section 11.2.5 before storing the programs in the
memory card for boot operation.
In the following procedure,
NO
Change the number of device points in the
Device tab of the PLC parameter dialog box.
NO
Set the initial device value range.
Set a file name for initial device value in the
PLC file tab of the PLC parameter dialog box.
11 - 12
indicates an operation on the CPU module side.
Start
Start GX Developer.
Set the project.
Change the number of
device points?
YES
Create a program to be executed
in the CPU module.
Use the initial device value?
YES
Set the device memory.
1)
GX Developer Version 8 Operating Manual
GX Developer Version 8 Operating Manual
Ladder (writing) screen
Section 6.25
Section 6.25
Section 6.25
Section 5.2.2)