Apply sealant to the oil pressure switch threads as
shown.
Install the oil pressure switch onto the crankcase,
tighten it to the specified torque.
TORQUE: 12 N*m (1.2 kgf.m, 9 I b f a )
Connect the oil pressure switch terminal to the switch
and tighten the screw t o the specified torque.
TORQUE: 2 Nem (0.2 kgf.rn, 1.4
Install the dust cover.
RESERVE SENSOR
FUEL
INSPECTION
If the fuel reserve indicator does not indicate proper-
ly, check for the following.
Open and support the front end of the fuel tank (page
3-4).
Disconnect the fuel reserve sensor 3P (Black) connec-
tor.
Short the wire harness side connector Brown/Black
and GreeniBlack terminals with a jumper wire.
Turn the ignition switch to "ON" and make sure the
fuel reserve indicator comes on.
If the indicator comes on, replace the fuel p u m p
a sse m b
If the indicator still does not come on, check for an
open or short circuit i n the wire harness.
I y.
Do
not apply sealant to
the thread head 3 - 4 mm
(0.1 - 0.2 in).
FUEL RESERVE INDICATOR
19-15