Honda 954 Service Manual page 324

CRANKCASE COMBINATl ON
Apply a light, but thorough coating of liquid sealantto
the crankcase mating surface except to the main bear-
ing journal bolt (lower crankcase bolt, 9
the oil passage area as shown.
Install the three dowel pins.
Install oil orifices aligning their cut-out
groove in the upper crankcase.
Install the swingarm pivot collars.
Tighten the main journal 9 mm bolts
Plastic Region tightening Method described below.
Do not reuse the main journal
the correct axial tension will not be obtained.
The main journal 9 mm bolt is pre-coated with an
oil additive for axial tension stability.
remove the oil additive f r o m the new 9 m m bolt sur-
face.
Install the lower crankcase onto the upper crankcase.
PLASTIC REGION TIGHTENING METHOD:
Install the new main journal 9 mm bolts.
Loosely install all the lower crankcase bolts.
Make sure the upper and lower crankcase are seated
securely.
Make sure the swingarm pivot collar flanges are seat-
ed in the crankcase securely.
Tighten the main journal 9 m m bolts as follow:
Tighten the 9 m m bolts i n numerical order i n the illus-
tration t o the following torque.
TORQUE:
Retighten the 9 mm bolts i n the same order above t o
the following torque..
TORQUE: 20 N*m (2.0 kgf*m, 14 I b f a )
Further tighten the 9 m m bolts 150 degrees.
11-12
9 m m bolts, because
(1.0 kgf.m, 7
area and
COLLARS
w i t h the
using the
Do not
OIL ORIFICES