Honda 954 Service Manual page 194

FUEL SYSTEM (Programmed Fuel Injection)
Connect the bank angle sensor 3P (Green) connector
and place the bank angle sensor horizontal as shown,
and ignition switch to "ON".
The bank angle sensor is normal if the engine stop
relay clicks and power supply is closed.
Incline the bank angle sensor approximately 60
degrees t o the left or right w i t h the ignition switch
t u r n e d t o
The bank angle sensor is normal if the engine slop
relay clicks and power supply is open.
If you repeat this test, first turn the ignition switch-to
"OFF", then turn the ignition switch to "ON".
RE M OVA L/I NSTALLATI 0 N
Disconnect the bank angle sensor 3P (Green) connector.
Remove the t w o screws, nuts and bank angle sensor.
install the bank
angle sensor with
Tighten the mounting screws securely.
ENGINE STOP RELAY
INSPECTION
Disconnect the engine stop relay 4P connector,
remove the engine stop relay.
5-86
.
0 N
60" BANK ANGLE POSITION
POSITION
I
,
60"
(approximately)
BANK ANGLE SENSOR
ENGINE STOP RELAY