Honda 954 Service Manual page 398

REAR
Remove the shock arm pivot needle bearing using the
special tool.
TOOL:
Needle bearing remover
Install the shock arm pivot needle bearing into the
swingarm so the needle bearing surface is lower 5.5
6.0 m m (0.22
face using the same tool.
TOOL:
Needle bearing remover
Apply grease t o the dust seal lips, then install the dust
seals and pivot collar into the swingarm.
' I 4-20
-
0.24 in) f r o m the end of the pivot sur-
NEEDLE BEARING REMOVER
-