Honda 954 Service Manual page 348

FRONT WHEEL/SUSPENSION/STEERlNG
INSTALLATION
Apply grease to the sliding surface of the throttle
pipe.
Install the clutch lever bracket t o the left handlebar,
and also the throttle pipe to the right handlebar.
Install the handlebars onto the fork sliders.
Install the top bridge while aligning its holes with the
handlebar stopper pins.
Install and tighten the steering stem nut t o the speci-
fied torque.
TORQUE: 103 N - m (10.5 kgf-m, 76 Ibf-ft)
Tighten the top bridge pinch bolts t o the specified
torque.
TORQUE: 23 N - m (2.3 kgfom, 17 Ibfaft)
Seat the handlebar pivot upper surface with the top
bridge lower surface, then tighten the handlebar
pinch bolt to the specified torque.
TORQUE: 26 N-m (2.7 kgfam, 20 Ibf-ft)
TOP BRIDGE