Honda 954 Service Manual page 299

Apply a locking agent to the threads of the set plate
bolts.
Install and set plates and bolts, tighten the bolts t o the
specified torque.
TORQUE: 12 N-m (1.2 kgf-m, 9 Ibf-ft)
Install the gearshift linkage (see following steps).
GEARSHIFT LINKAGE INSTALLATION
Install the following:
-
Washer
-
Return spring
-
Stopper arm
-
Socket bolt
Tighten the stopper arm socket bolt t o the specified
torque.
TORQUE: 12 N-m (1.2 kgf-m, 9 Ibfqft)
Install the dowel pin onto the shift drum.
Install the gearshift cam while holding the stopper
pin on the shift arm using a screwdriver as shown.
drum center with
the wide groove
on rhe gearshift
cam
threads.
Install and tighten the socket bolt t o the specified
torque.
TORQUE: 23 N-m (2.3 kgf-m, 17 Ibf-ft)
9-16
the gearshift cam socket bolt