Honda 954 Service Manual page 200

FUEL SYSTEM (Programmed
Route the 0 2 sensor wire into the frame.
Connect the 0 2 sensor
EGCV A N D AIR INTAKE VALVE
I N S PECTlO N
Before operating inspection, check that the PGM-FI
MIL does not indicate an EGCV failure.
Remove the lower cowl (page 2-7).
Remove the air cleaner element (page 3-6).
Remove the bolts and EGCV pulley cover.
Turn the ignition switch to "ON" and check for EGCV
cable guide pulley position.
Make sure the pulley index line is positioned 90"
(facing forward) as shown.
Start the engine, and warm it u p t o operating temper-
ature.
Gradually increase the engine rev up.
Make sure the EGCV cable pulley is moved t o 0"
(pulley index line facing up) at about 3,000 rpm as
shown.
5-92
Fuel
Injection)
4P (Natural) connector.
I