Honda 954 Service Manual page 382

REAR WHEEL/SUSPENSION
Wheel bearing
Turn the inner race of each bearing w i t h your finger.
Bearings should turn smoothly and quietly.
check that the bearing outer race fits tightly i n the
hub.
Remove and discard the bearings if the races do not
turn smoothly and quietly, or if they fit loosely in the
hub.
Wheel rim runout
Check the r i m runout by placing the wheel i n a true-
ing stand.
Spin the wheel slowly and read the runout using a
dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS: Radial:
Driven sprocket
Check the condition of the final driven sprocket teeth.
Replace the sprocket if w o r n or damaged.
If the final driven sprocket requires replacement,
inspect the drive chain and drive sprocket.
Never install a new drive chain o n a w o r n sprocket
or a w o r n chain o n new sprockets. Both chain and
sprocket must be i n good condition or the replace-
ment chain or sprocket will wear rapidly.
Wheel balance
See page 13-11 for wheel balance.
DISASSEMBLY
Remove the bolts and brake disc.
Remove the right dust seal.
2.0 mm (0.08 in)
Axial: 2.0 m m in)
(0.08
Also
W HE E L B EARING
GOOD
REPLACE
X