Honda 954 Service Manual page 45

2, FRAME/BODY P
BODY PANEL LOCATIONS
SERVICE INFORMATION
TROUBLESHOOTING
SEAT
PILLION SEAT/REAR COWL
DUCT COVER
UPPER COWL
SERVICE INFORMATION
GENERAL
This section covers removal and installation of the
Always replace the exhaust pipe gaskets after removing the exhaust pipe from the engine.
When installing the exhaust system, loosely install all of the exhaust pipe fasteners. Always tighten the exhaust clamps
first, then tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat prop-
erly.
Always inspect the exhaust system for leaks after installation.
TORQUE VALUES
Upper cowl pan screw
Lower cowl pan screw
Rear cowl truss screw
Pillion seat mounting nut
Pillion seat hinge special screw
Duct cover mounting screw
Windscreen mounting screw
Seat rail mounting bolt, 8 mm
Seat rail mounting nut, 10 mm
Pillion step mounting socket bolt
Exhaust pipe joint nut
EGCV cover mounting b o l t
EGCV pulley cover mounting bolt
TROUBLESHOOTING
Excessive
exhaust noise
Broken exhaust system
Exhaust gas leak
Poor performance
Deformed exhaust system
Exhaust gas leak
Clogged muffler
EL EXHAUST SYST
LOWER COWL
2-0
2- 1 INNER MIDDLE COWL
2- WINDSCREEN
1
2-2 FRONT FENDER
2-2 REAR FENDER
2-4 SEAT RAIL
MUFFLER/EXHAUST PIPE
2-5
body panels and exhaust system.
1.5 N * m (0.15 kgf*m, 1.1 Ibf-ft)
1.5 N * m (0.15 kgf-m, 1.1 Ibf-ft)
1.5 N - m (0.15 kgf-m,
1.1
11 N - m (1.1 kgfom, 8 Ibf-ft)
12 N - m (1.2 kgf-m, 9 Ibf-ft)
1.5 N * m (0.15 kgf-m, 1.1 Ibf-ft)
0.3 N * m (0.03 kgfom, 0.22 Ibf-ft)
39 N*m (4.0 kgf-m, 29 Ibfoft)
39 N - m (4.0 kgfom, 29 Ibf-ft)
39 N * m (4.0 kgfom, 29 Ibf*ft)
12 N - m 1.2 kgf-m, 9 Ibf-ft)
12 N-m 1.2 k g f m , 9 lbf*ft)
12 N - m 1.2 kgf-m, 9 IbfW
U-nut
2-7
2-7
2-9
2-1 1
2-1 3
2-1