Honda 954 Service Manual page 176

FUEL SYSTEM (Programmed Fuel Injection)
Loosen the engine side insulator band screws.
Remove the throttle body from the cylinder head.
Do not hold the fuel pipe on the throttle body while
removing the throttle body.
Do not snap the Remove the insulators from the throttle body.
throttle valve from
fuii open to fuii
NOTICE
ciose after the
Seal the cylinder head intake ports with tape o r a
been removed it
clean cloth to keep dirt and debris from entering the
may cause incor-
intake ports after the throttle body has been removed.
rect idle opera-
tion
Do not damage the throttle body. It may cause incorrect throttle and idle valve synchronization.
The throttle body is factory pre-set. Do not disassemble in a way other than shown in this manual.
Do not loosen or tighten the white painted bolts and screws o f the throttle body. Loosening or tightening
them can cause throttle and idle valve synchronization failure.
TOP VIEW:
5-68
INSULATORS