Honda 954 Service Manual page 396

REAR WHEEL/SUSPENSION
PIVOT BEARING REPLACEMENT
Remove the snap ring from the swingarm right pivot.
Remove the right pivot bearings (radial ball bearing
and needle bearing) f r o m the swingarm pivot using
the special tools and hydraulic press.
TOOLS:
Driver shaft
Driver attachment, 25 x
Pack a new needle bearing w i t h grease.
Press the inner bearing into the swingarm right pivot
until it seats using the special tools and hydraulic
press.
TOOLS:
Driver
Attachment, 40 x 42 m m
Pilot, 25 m m
Pack a new bearing with gre se.
Install the outer bearing using the special tools.
TOOLS:
Driver
Attachment, 40 x 42 mm
Pilot, 25 m m
14-18
m m 07YMD-MCJ0100
07749-0010000
07746-0010900
07746-0040600
07749-0010000
07746-0010900
07746-0040600