Install the friction spring and new special snap ring.
You must use a n e w special snap ring. Using a snap
ring other than specified or reusing the original snap
ring can cause severe engine damage.
install a new special snap ring with its large tab fac-
ing t o the right and the chamfered side facing
Make sure the new special snap ring end gap is
aligned with the right angle of the crankshaft cut-
outs as shown.
STARTER CLUTCH NEEDLE BEARING
REPLACEMENT
To protect the
crankshaft main
journal from the
bearing puller
claws, cover the
main journal prop-
erly, worn main
journal bearings
are usable as pro-
tectors
Press a new needle bearing onto the crankshaft using
a hydraulic press and special tool.
TOOL:
Driver shaft
in.
07964-NIB00200
NEEDLE BEARING
FRICTION SPRING
CUT-OUTS
- -
SHAFT
12-5