Honda 954 Service Manual page 210

FUEL SYSTEM
(Programmed
Install the thrust spring onto the EGCV cover.
M a k e sure the
spring
thrust is
Install the spring retainer assembly onto the thrust
boss
Install the valve cable guide pulley aligning its cut-out
with the the valve shaft tab as shown.
Install the valve cable guide pulley flange nut.
Turn the valve cable guide pulley clockwise, seat the
pulley tab with the stopper o n the valve cover.
Tighten the nut t o the specified torque.
TORQUE: 12 N.m (1.2 kgf-m, 9 Ibf-ft)
Check the EGCV pre-load using a torque wrench.
PRE-LOAD:
0.34 N-m (0.035 kgf-m, 0.25 Ibfoft) maximum
If pre-load is excessive, reassemble the EGCV.
Fuel Injection)
NUT
I