Chapter 90 Q-In-Q Commands - D-Link xStack DGS-3620 Reference Manual

Hide thumbs Also See for xStack DGS-3620:

Table of Contents

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

disable qinq

config qinq ports [<portlist> | all] {role [uni | nni] | missdrop [enable | disable] | outer_tpid <hex

[add | delete] vlan_translation_profile <profile_id>}(1)

config qinq inner_tpid <hex 0x1-0xffff>

show qinq inner_tpid

show qinq ports {<portlist>}

create vlan_translation ports [<portlist> | all] [add cvid <vidlist> | replace cvid <vlanid 1-4094>]

svid <vlanid 1-4094> {priority <priority 0-7>}

delete vlan_translation ports [<portlist> | all] {cvid <vidlist>}

show vlan_translation {[ports <portlist> | cvid <vidlist>]}

create vlan_translation_profile <profile_id>

config vlan_translation_profile <profile_id> add rule_id {<rule_id>} [add svid <vlanid 1-4094>

{priority <priority 0-7>} classify {source_mac <macaddr> {sa_mask <macmask>} |

destination_mac <macaddr> {da_mask <macmask>} | source_ipv4 <ipaddr> {sip_mask

<netmask>} | destination_ipv4 <ipaddr> {dip_mask <netmask>} | outer_vid <vidlist> | 802.1p

<priority 0-7> | ip_protocol <value 0-255> | l4_src_port <value 1-65535> | l4_dest_port <value

1-65535>} | replace svid <vlanid 1-4094> {priority <priority 0-7>} classify outer_vid <vlanid 1-

4094> {source_mac <macaddr> {sa_mask <macmask>} | destination_mac <macaddr>

{da_mask <macmask>} | source_ipv4 <ipaddr> {sip_mask <netmask>} | destination_ipv4

<ipaddr> {dip_mask <netmask>} | 802.1p <priority 0-7> | ip_protocol <value 0-255> |

l4_src_port <value 1-65535> | l4_dest_port <value 1-65535>}]

show vlan_translation_profile {<profile_id_list>}

delete vlan_translation_profile [<profile_id> | all] {rule_id [<rule_id_list> | all]}

This command is used to enable Q-in-Q. When Q-in-Q is enabled, all network port roles will be

NNI ports and the outer TPID will be set according to the user's configuration. All existing static

VLANs will run as S-VLAN. All dynamic learned L2 addresses will be cleared. All dynamic

registered VLAN entries will be cleared. GVRP will be disabled. To run GVRP on the switch, the

administrator should enable GVRP manually. In Q-in-Q mode, GVRP protocol will employ the

reserve address 01-80-C2-00-00-0D. The default setting of Q-in-Q is disabled.

Restrictions

Only Administrators, Operators and Power-Users can issue this command.

Q-in-Q Commands

Chapters

Table of Contents