Console Show Commands; Show Console Config - Nortel Versalar 15000 Reference Manual

Console Show Commands

This section describes the console show commands and the information in the
tables the router displays.

show console config

Enter the
environment information for the serial ports configured on your system or for a
specific port. The output includes the following information:
Port Number
Port Name
State
Baud Rate
Data Bits
Parity
Stop Bits
308689-B Rev 00
show console config
Port number for the information displayed. Valid ports are
1, 2, 3, and 4. Not all systems have four physical ports. A
configured port that does not exist is in the Absent state.
Name that the system assigns to the port. You cannot
specify a name. You can use the name to correlate a port
number to a physical port. The name of the port should
be printed next to the physical port connection, for
example, Port 1 - CONSOLE.
The names do not specify the port's use. All ports are
serial ports used for BCC sessions only. For example,
port MODEM1 may be a modem connection or a dummy
terminal connection depending on its configuration.
Although port 4 is called PRINTER, it is exactly like ports
1, 2, and 3. Port 4 does not support a printer. Port 4 is
called PRINTER only because that label is printed near
the port connector on the link module.
Port's current state, as follows:
•
•
•
•
•
Current baud rate setting for the serial port.
Number of data bits in the serial port's configuration.
Serial port's current parity setting.
Number of stop bits in the serial port's configuration.
command to display configuration and BCC
Absent -- Not physically present
Disabled -- Unavailable
Down -- Unavailable
Init -- Initializing
Up -- Available
show console config
29