Jumbo Frame Commands - D-Link xStack DES-6500 Cli Manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Certain switches can support jumbo frames (frames larger than the standard Ethernet frame size of 1518 bytes). To transmit
frames of up to 9216 bytes (and 9220 bytes tagged), the user can increase the maximum transmission unit (MTU) size from the
default of 1536 by enabling the Jumbo Frame command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command will allow ethernet frames larger than 1536 bytes to
be processed by the Switch. The maximum size of the jumbo frame
may not exceed 9216 bytes.
None.
None.
DES-6500:4#enable jumbo_frame
Command: enable jumbo_frame
Success.
DES-6500:4#
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command will disable the jumbo frame function on the Switch.
None.
None.
J
UMBO
353
F C
RAME OMMANDS
41