D-Link xStack DES-6500 Cli Manual page 188

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config authen parameter attempt
Parameters
Restrictions
Example usage:
To set the maximum number of authentication attempts at 5:
D E S - 6 5 0 0 : 4 # c o n f i g a u t h e n p a r a m e t e r a t t e m p t 5
C o m m a n d : c o n f i g a u t h e n p a r a m e t e r a t t e m p t 5
S u c c e s s .
D E S - 6 5 0 0 : 4 #
show authen parameter
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the authentication parameters currently located on the Switch:
D E S - 6 5 0 0 : 4 # s h o w a u t h e n p a r a m e t e r
C o m m a n d : s h o w a u t h e n p a r a m e t e r
R e s p o n s e t i m e o u t : 6 0 s e c o n d s
U s e r a t t e m p t s
D E S - 6 5 0 0 : 4 #
disconnected from the Switch.
parameter attempt <int 1-255> - Set the maximum number of
attempts the user may try to become authenticated by the Switch,
before being locked out. The default setting is 3 attempts.
Only Administrator-level users can issue this command.
Used to display the authentication parameters currently configured
on the Switch.
show authen parameter
This command will display the authentication parameters currently
configured on the Switch, including the response timeout and user
authentication attempts.
This command will display the following fields:
Response timeout – The configured time allotted for the Switch to
wait for a response of authentication from the user attempting to log
in from the command line interface or telnet interface.
User attempts – The maximum number of attempts the user may try
to become authenticated by the Switch, before being locked out.
None.
None.
: 5
184