D-Link xStack DES-6500 Cli Manual page 265

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
P l e a s e w a i t f o r A C K . . .
S I M C o n f i g S u c c e s s ! ! !
S u c c e s s .
D E S - 6 5 0 0 : 4 #
To delete a member:
D E S - 6 5 0 0 : 4 # c o n f i g s i m _ g r o u p d e l e t e 1
C o m m a n d : c o n f i g s i m _ g r o u p d e l e t e 1
P l e a s e w a i t f o r A C K . . .
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config sim
Purpose
Syntax
Description
Parameters
Used to configure role parameters for the SIM protocol on the Switch.
config sim [{[commander {group_name <groupname 64>} |
candidate] | dp_interval <sec 30-90> | hold_time <sec 100-255>}
This command is used to configure parameters of switches of the SIM.
commander – Use this parameter to configure the commander switch for
the following parameters:
group_name <groupname 64> - Used to update the name of the group.
Enter an alphanumeric string of up to 64 characters to rename the SIM
group.
dp_interval <30-90> – The user may set the discovery protocol interval,
in seconds that the Switch will send out discovery packets. Returning
information to the commander switch will include information about other
switches connected to it. (Ex. MS, CaS). The user may set the discovery
protocol interval from 30 to 90 seconds.
hold time <sec 100-255> – Using this parameter, the user may set the
time, in seconds, the Switch will hold information sent to it from other
switches, utilizing the discovery interval protocol. The user may set the
hold time from 100 to 255 seconds.
candidate – Used to change the role of a commander switch to a
candidate switch.
dp_interval <30-90> – The user may set the discovery protocol interval,
in seconds that the Switch will send out discovery packets. Returning
information to the commander switch will include information about other
switches connected to it. (Ex. MS, CaS). The user may set the
dp_interval from 30 to 90 seconds.
hold time <sec 100-255> – Using this parameter, the user may set the
time, in seconds, the Switch will hold information sent to it from other
switches, utilizing the discovery interval protocol. The user may set the
261