D-Link xStack DES-6500 Cli Manual page 213

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config 802.1x capability ports
Description
Parameters
Restrictions
Example usage:
To configure 802.1x capability on ports 1-10 on line card 1:
D E S - 6 5 0 0 : 4 # c o n f i g 8 0 2 . 1 x c a p a b i l i t y p o r t s 1 : 1 – 1 : 1 0
a u t h e n t i c a t o r
C o m m a n d : c o n f i g 8 0 2 . 1 x c a p a b i l i t y p o r t s 1 : 1 – 1 : 1 0
a u t h e n t i c a t o r
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config 802.1x auth_parameter
Purpose
Syntax
Description
Parameters
none]
The config 802.1x command has two capabilities that can be set for
each port, authenticator and none.
<portlist>  Specifies a range of ports. The port list is specified by
listing the lowest line card number and the beginning port number on
that line card, separated by a colon. Then the highest line card number,
and the highest port number of the range (also separated by a colon)
are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies line card number 1,
port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all of
the ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
all  Specifies all of the ports on the Switch.
authenticator  A user must pass the authentication process to gain
access to the network.
none  The port is not controlled by the 802.1x functions.
Only Administrator-level users can issue this command.
Used to configure the 802.1x Authentication parameters on a range of
ports. The default parameter will return all ports in the specified range
to their default 802.1x settings.
config 802.1x auth_parameter ports [<portlist> | all]
{direction [both | in] | port_control [force_unauth | auto |
force_auth] | quiet_period <sec 0-65535>| tx_period <sec 1-65535>
| supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> |
max_req <value 1-10> | reauth_period <sec 1-65535> |
enable_reauth [enable | disable]}]
The config 802.1x auth_parameter command is used to configure the
802.1x Authentication parameters on a range of ports. The default
parameter will return all ports in the specified range to their default
802.1x settings.
<portlist>  Specifies a range of ports. The port list is specified by
listing the lowest line card number and the beginning port number on
that line card, separated by a colon. Then the highest line card number,
209
[default |