D-Link xStack DES-6500 Cli Manual page 346

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
DES-6500:4#
delete ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To configure the OSPF area aggregation settings:
DES-6500:4#delete ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary
Command:
lsdb_type summary
Success.
DES-6500:4#
config ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
Used to delete an OSPF area aggregation configuration.
delete ospf aggregation <area_id> <network_address> lsdb_type
summary
This command is used to delete an OSPF area aggregation
configuration.
<area_id>  A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address>  The 32-bit number in the form of an IP address
that uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type summary  Specifies the type of address aggregation.
Only Administrator-level users can issue this command.
delete ospf aggregation 10.1.1.1 10.48.76..122/16
Used to configure the OSPF area aggregation settings.
config ospf aggregation <area_id> <network_address> lsdb_type
summary {advertise [enabled | disabled]}
This command is used to configure the OSPF area aggregation settings.
<area_id>  A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address>  The 32-bit number in the form of an IP address
that uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type summary  Specifies the type of address aggregation.
advertise [enabled | disabled]  Allows for the advertisement trigger to
be enabled or disabled.
Only Administrator-level users can issue this command.
342