D-Link xStack DES-6500 Cli Manual page 214

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config 802.1x auth_parameter
Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
D E S - 6 5 0 0 : 4 # c o n f i g 8 0 2 . 1 x a u t h _ p a r a m e t e r p o r t s 1 : 1 – 1 : 2 0
d i r e c t i o n b o t h
C o m m a n d : c o n f i g 8 0 2 . 1 x a u t h _ p a r a m e t e r p o r t s 1 : 1 – 1 : 2 0
d i r e c t i o n b o t h
and the highest port number of the range (also separated by a colon)
are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies line card number 1,
port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all of
the ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
all  Specifies all of the ports on the Switch.
default  Returns all of the ports in the specified range to their 802.1x
default settings.
direction [both | in]  Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or just
the receiving direction.
port_control  Configures the administrative control over the
authentication process for the range of ports. The user has the
following authentication options:
force_auth  Forces the Authenticator for the port to become

authorized. Network access is allowed.
auto  Allows the port's status to reflect the outcome of the

authentication process.
force_unauth  Forces the Authenticator for the port to

become unauthorized. Network access will be blocked.
quiet_period <sec 0-65535>  Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response
from a supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for
a response from a RADIUS server.
max_req <value 1-10>  Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535>  Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable]  Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of users
at the time interval specified in the Re-authentication Period field,
above.
Only Administrator-level users can issue this command.
210