D-Link xStack DES-6500 Cli Manual page 321

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config pim register_suppression_time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the register suppression time:
DES-6500:4#config pim register_suppression_time 15
Command: config pim register_suppression_time 15
Success.
DES-6500:4#
create pim crp
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To create an IP interface to become a Candidate RP on the Switch:
Used to configure the interval between the sending of register packets for
the PIM protocol.
config pim register_suppression_time <value 3-255>
This command is to be configured for the first hop router from the source.
After this router sends out a register message to the RP, and the RP replies
with a register stop message, it will wait for the time configured here to send
out another register message to the RP. This command is for PIM-SM
configurations only.
<value 3-255> - The user may set an interval time between 3-255 with a
default setting of 60 seconds for the sending of register suppression time
packets. The default value is 60 seconds.
Only Administrator-level users can issue this command.
NOTE: The Probe time value must be less than half of the Register
Suppression Time value. If not, the administrator will be presented with a
Fail message.
To enable the Switch to become a candidate to be the Rendezvous
Point (RP).
create pim crp group <ip_addr/netmask> rp <ipif_name 12>
This command will set the parameters for the switch to become a
candidate RP. This command is for PIM-SM configurations only.
group <ip_addr/netmask> - Enter the multicast group address for this
switch to become a Candidate RP. This address must be a class D
address.
rp <ipif_name 12> - Enter the name of the PIM-SM enabled interface
the switch administrator wishes to become the CRP for this group.
Only administrator-level users can use this command.
317