D-Link xStack DES-6500 Cli Manual page 256

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
S u c c e s s .
D E S - 6 5 0 0 : 4 #
show traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current traffic segmentation configuration on the Switch.
D E S - 6 5 0 0 : 4 # s h o w t r a f f i c _ s e g m e n t a t i o n
C o m m a n d : s h o w t r a f f i c _ s e g m e n t a t i o n
T r a f f i c S e g m e n t a t i o n T a b l e
P o r t
- - - -
1 : 1
1 : 2
1 : 3
1 : 4
1 : 5
1 : 6
1 : 7
1 : 8
1 : 9
1 : 1 0
1 : 1 1
Used to display the current traffic segmentation configuration on the
Switch.
show traffic_segmentation <portlist>
The show traffic_segmentation command is used to display the current
traffic segmentation configuration on the Switch.
<portlist>  Specifies a range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The port list
is specified by listing the lowest line card number and the beginning port
number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies line card number 1, port
3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all of the
ports between line card 1, port 3 and line card 2, port 4  in numerical
order.
The port lists for segmentation and the forward list must be on the same
switch.
F o r w a r d P o r t l i s t
- - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
1 : 1 - 1 : 1 0 , 2 : 1 - 2 : 1 2
252