D-Link xStack DES-6500 Cli Manual page 274

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config dst
Restrictions
Example usage:
To configure daylight savings time on the Switch:
DES-6500:4#config dst repeating s_week 2 s_day tue
s_mth 4 s_time 15:00 e_week 2 e_day wed e_mth 10 e_time
15:30 offset 30
Command: config dst repeating s_week 2 s_day tue s_mth
4 s_time 15:00 e_week 2 e_day wed e_mth 10 e_time 15:30
offset 30
October 14.
s_week - Configure the week of the month in which DST begins.

<start_week 1-4,last> - The number of the week during the month in
which DST begins where 1 is the first week, 2 is the second week and
so on, last is the last week of the month.
e_week - Configure the week of the month in which DST ends.

<end_week 1-4,last> - The number of the week during the month in
which DST ends where 1 is the first week, 2 is the second week and
so on, last is the last week of the month.
s_day – Configure the day of the week in which DST begins.

<start_day sun-sat> - The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue, wed,
thu, fri, sat).
e_day - Configure the day of the week in which DST ends.

<end_day sun-sat> - The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue, wed,
thu, fri, sat).
s_mth - Configure the month in which DST begins.

<start_mth 1-12> - The month to begin DST expressed as a number.
e_mth - Configure the month in which DST ends.

<end_mth 1-12> - The month to end DST expressed as a number.
s_time – Configure the time of day to begin DST.

<start_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
e_time - Configure the time of day to end DST.

<end_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
s_date - Configure the specific date (day of the month) to begin DST.

<start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to begin DST.

<end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30, 60, 90, 120. The
default value is 60.
Only Administrator-level users can issue this command.
270