D-Link xStack DES-6500 Cli Manual page 217

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config 802.1x reauth ports
Restrictions
Example usage:
To configure 802.1x reauthentication for ports 1-18 on line card 1:
D E S - 6 5 0 0 : 4 # c o n f i g 8 0 2 . 1 x r e a u t h p o r t _ b a s e d p o r t s
1 : 1 - 1 : 1 8
C o m m a n d : c o n f i g 8 0 2 . 1 x r e a u t h p o r t _ b a s e d p o r t s 1 : 1 -
1 : 1 8
S u c c e s s .
D E S - 6 5 0 0 : 4 #
mac-based - This instructs the Switch to re-authorize 802.1x function
based on a specific MAC address. Ports approved for re-authorization
can then be specified.
 ports <portlist>  Specifies a range of ports. The port list is
specified by listing the lowest line card number and the beginning
port number on that line card, separated by a colon. Then the
highest line card number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies line card number 1, port 3. 2:4 specifies
line card number 2, port 4. 1:3-2:4 specifies all of the ports
between line card 1, port 3 and line card 2, port 4  in numerical
order.
 all  Specifies all ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the client to
add.
Only Administrator-level users can issue this command.
213