D-Link xStack DES-6500 Cli Manual page 319

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
disable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To disable PIM on the Switch:
DES-6500:4#disable pim
Command: disable pim
Success.
DES-6500:4#
config pim
Purpose
Syntax
Description
Parameters
Used to disable PIM function on the Switch.
disable pim
This command will disable PIM for the Switch. Any previously
configured PIM settings will remain unchanged and may be enabled at
a later time with the enable pim command.
None.
Only Administrator-level users can issue this command.
Used to configure the parameters for the PIM protocol.
config pim [ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval
<sec 1-18724> | state [enable | disable] | mode [dm | sm] | dr_priority
<uint 0 – 4294967294>}
This command will configure the general settings for the PIM protocol per
IP interface, including choice of PIM mode, Designated Router priority and
various timers.
ipif <ipif_name 12> - Enter an IP interface for which to configure the PIM
settings. This name cannot exceed 12 alphanumeric characters.
all – Select this parameter to configure PIM settings for all IP interfaces on
the Switch.
hello <sec 1-18724> - Used to set the interval time between the sending of
Hello Packets from this IP interface to neighboring routers one hop away.
These Hello packets are used to discover other PIM enabled routers and
state their priority as the Designated Router (DR) on the PIM enabled
network. The user may state an interval time between 1 – 18724 seconds
with a default interval time of 30 seconds.
jp_interval <sec 1-18724> - This field will set the interval time between the
sending of Join/Prune packets stating which multicast groups are to join
the PIM enabled network and which are to be removed or "pruned" from
that group. The user may state an interval time between 1 – 18724
seconds with a default interval time of 30 seconds.
state [enable | disable] - Used to enable or disable PIM for this IP
interface. The default is Disabled.
mode [dm | sm] - Used to select the type of PIM protocol to use, Sparse
Mode (SM) or Dense Mode (DM). The default setting is DM.
315