D-Link xStack DES-6500 Cli Manual page 320

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config pim
Restrictions
Example usage:
To configure the PIM settings for an IP interface:
DES-6500:4#config pim ipif Trinity hello 60 jp_interval 60 state
enable mode sm dr_priority 2
Command: config pim ipif Trinity hello 60 jp_interval 60 state
enable mode sm dr_priority 2
Success.
DES-6500:4#
config pim register_probe_time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the register probe time:
DES-6500:4#config pim register_probe_time 5
Command: config pim register_probe_time 5
Success.
DES-6500:4#
dr_priority <uint 0 – 4294967294> - Enter the priority of this IP interface to
become the Designated Router for the multiple access network. The user
may enter a DR priority between 0 and 4,294,967,294 with a default
setting of 1.
Only Administrator-level users can issue this command.
Used to set a time to send a probe message from the DR to the RP before
the Register Suppression time expires.
config pim register_probe_time <value 1-127>
This command is used to set a time to send a probe message from the DR
to the RP before the Register Suppression time expires. If a Register Stop
message is received by the DR, the Register Suppression Time will be
restarted. If no Register Stop message is received within the probe time,
Register Packets will be resent to the RP. This command is for PIM-SM
configurations only.
<value 1-127> - Configure this field to set a time to send a probe message
from the DR to the RP before the Register Suppression time expires. The
user may configure a time between 1-127 seconds with a default setting of
5 seconds.
Only Administrator-level users can issue this command.
316