D-Link xStack DES-6500 Cli Manual page 197

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config ssh algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 |
arcfour | blowfish | cast128 | twofish128 | twofish192 |
twofish256 | MD5 | SHA1 | DSA | RSA | ALL] [enable | disable]
This command allows you to configure the desired type of SSH
algorithm used for authentication encryption.
3DES – This parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced
Encryption Standard AES256 encryption algorithm.
arcfour - This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish - This parameter will enable or disable the Blowfish
encryption algorithm.
cast128 - This parameter will enable or disable the Cast128
encryption algorithm.
twofish128 - This parameter will enable or disable the twofish128
encryption algorithm.
twofish192 - This parameter will enable or disable the twofish192
encryption algorithm.
twofish1256 - This parameter will enable or disable the twofish 256
encryption algorithm.
MD5 - This parameter will enable or disable the MD5 Message
Digest encryption algorithm.
SHA1 - This parameter will enable or disable the Secure Hash
Algorithm encryption.
DSA - This parameter will enable or disable the Digital Signature
Algorithm encryption.
RSA - This parameter will enable or disable the RSA encryption
algorithm.
ALL – This parameter will enable all encryptions listed above.
[enable | disable] – This allows the user to enable or disable
algorithms entered in this command, on the Switch.
Only Administrator-level users can issue this command.
193