D-Link xStack DES-6500 Cli Manual page 23

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
enable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
disable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:
D E S - 6 5 0 0 : 4 # d i s a b l e c l i p a g i n g
C o m m a n d : d i s a b l e c l i p a g i n g
S u c c e s s .
D E S - 6 5 0 0 : 4 #
Used to enable communication with and management of the Switch
using the Telnet protocol.
enable telnet <tcp_port_number 1-65535>
This command is used to enable the Telnet protocol on the Switch. The
user can specify the TCP or UDP port number the Switch will use to
listen for Telnet requests.
<tcp_port_number 1-65535>
numbered between 1 and 65535. The "well-known" TCP port for the
Telnet protocol is 23.
Only Administrator-level users can issue this command.
D E S - 6 5 0 0 : 4 # e n a b l e t e l n e t 2 3
C o m m a n d : e n a b l e t e l n e t 2 3
S u c c e s s .
D E S - 6 5 0 0 : 4 #
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the Switch.
None.
Only Administrator-level users can issue this command.
D E S - 6 5 0 0 : 4 # d i s a b l e t e l n e t
C o m m a n d : d i s a b l e t e l n e t
S u c c e s s .

The TCP port number. TCP ports are
19