D-Link xStack DES-6500 Cli Manual page 72

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show error ports
Description
Parameters
Restrictions
Example usage:
To display the errors of the port 3 of module 1:
D E S - 6 5 0 0 : 4 # s h o w e r r o r s p o r t s 1 : 3
C o m m a n d : s h o w e r r o r s p o r t s 1 : 3
T X F r a m e s
- - - - - - - - - - - - - - - -
C R C E r r o r
U n d e r s i z e
O v e r s i z e
F r a g m e n t
J a b b e r
D r o p P k t s
C T R L + C E S C q Q u i t S P A C E n N e x t P a g e p P r e v i o u s
P a g e r R e f r e s h
show utilization
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
This command will display all of the packet error statistics
collected and logged by the Switch for a given port list.
<portlist>  Specifies a range of ports to be displayed. The port
list is specified by listing the lowest line card number and the
beginning port number on that line card, separated by a colon.
Then the highest line card number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies line card number 1, port 3. 2:4
specifies line card number 2, port 4. 1:3-2:4 specifies all of the
ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
None.
1 9 E x c e s s i v e D e f e r r a l
0 C R C E r r o r
0 L a t e C o l l i s i o n
0 E x c e s s i v e C o l l i s i o n
1 1 S i n g l e C o l l i s i o n
2 0 8 3 7
Used to display real-time port and CPU utilization statistics.
show utilization [ports | cpu]
This command will display the real-time port and CPU utilization
statistics for the Switch.
cpu – Entering this parameter will display the current CPU
utilization of the Switch, as a percentage.
ports – Entering this parameter will display the current utilization of
all ports on the Switch.
None.
68
R X F r a m e s
- - - - - - - - - - - - - - -
C o l l i s i o n
0
0
0
0
0
0