xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show ospf host_route
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display the current OSPF host route table:
DES-6500:4#show ospf host_route
Command: show ospf host_route
Host Address
---------------
10.48.73.21
10.48.74.122
Total Entries: 2
DES-6500:4#
create ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To create an OSPF area aggregation:
DES-6500:4#create ospf aggregation 10.1.1.1
10.48.76.122/16 lsdb_type summary advertise enable
Command: create ospf aggregation 10.1.1.1
10.48.76.122/16 lsdb_type summary advertise enable
Success.
Used to display the current OSPF host route table.
show ospf host_route {<ipaddr>}
This command will display the current OSPF host route table.
<ipaddr> The IP address of the host.
None.
Metric
---------------
2
1
Used to configure OSPF area aggregation settings.
create ospf aggregation <area_id> <network_address> lsdb_type
summary {advertise [enabled | disabled]}
This command is used to create an OSPF area aggregation.
<area_id> A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address> The 32-bit number in the form of an IP address
that uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type summary The type of address aggregation.
advertise [enabled | disabled] Allows for the advertisement trigger to
be enabled or disabled.
Only Administrator-level users can issue this command.
Area_ID
-----------
10.1.1.1
10.1.1.1
341