xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config gvrp
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
D E S - 6 5 0 0 : 4 # c o n f i g g v r p 1 : 1 - 1 : 4 s t a t e e n a b l e d
i n g r e s s _ c h e c k i n g e n a b l e d a c c e p t a b l e _ f r a m e t a g g e d _ o n l y
p v i d 2
C o m m a n d : c o n f i g g v r p 1 : 1 - 1 : 4 s t a t e e n a b l e d
i n g r e s s _ c h e c k i n g e n a b l e d a c c e p t a b l e _ f r a m e t a g g e d _ o n l y
p v i d 2
S u c c e s s .
D E S - 6 5 0 0 : 4 #
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
D E S - 6 5 0 0 : 4 # e n a b l e g v r p
C o m m a n d : e n a b l e g v r p
S u c c e s s .
D E S - 6 5 0 0 : 4 #
disable gvrp
Purpose
Syntax
Description
by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Only Administrator-level users can issue this command.
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable and
disable GVRP globally on the Switch, without changing the GVRP
configuration on the Switch.
None.
Only Administrator-level users can issue this command.
Used to disable GVRP on the Switch.
disable gvrp
This command, along with enable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP
133