D-Link xStack DES-6500 Cli Manual page 339

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Command
create ospf virtual_link
config ospf virtual_link
delete ospf virtual_link
show ospf virtual_link
Each command is listed, in detail, in the following sections.
config ospf router_id
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To configure the OSPF router ID:
enable ospf
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To enable OSPF on the Switch:
DES-6500:4#enable ospf
Command: enable ospf
Success.
Parameters
<area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec
1-65535> | authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
<area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval <sec
1-65535> | authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
<area_id> <neighbor_id>
{<area_id> <neighbor_id>}
Used to configure the OSPF router ID.
config ospf router_id <ipaddr>
This command is used to configure the OSPF router ID.
<ipaddr>  The IP address of the OSPF router.
Only Administrator-level users can issue this command.
DES-6500:4#config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DES-6500:4#
Used to enable OSPF on the Switch.
enable ospf
This command, in combination with the disable ospf command below, is
used to enable and disable OSPF on the Switch.
None.
Only Administrator-level users can issue this command.
335