D-Link xStack DES-6500 Cli Manual page 54

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
S u c c e s s .
D E S - 6 5 0 0 : 4 #
show snmp host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
D E S - 6 5 0 0 : 4 # s h o w s n m p h o s t
C o m m a n d : s h o w s n m p h o s t
S N M P H o s t T a b l e
H o s t I P A d d r e s s
- - - - - - - - - - - - - - -
1 0 . 4 8 . 7 6 . 2 3
1 0 . 4 8 . 7 4 . 1 0 0
T o t a l E n t r i e s : 2
DES-6500:4#
create trusted_host
Purpose
Syntax
Description
Parameters
Used to display the recipient of SNMP traps generated by the Switch's
SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps that are generated by the
Switch's SNMP agent.
<ipaddr>  The IP address of a remote SNMP manager that will
receive SNMP traps generated by the Switch's SNMP agent.
None.
S N M P V e r s i o n
- - - - - - - - - - - - - - - - - - - - -
V 2 c
V 3
Used to create the trusted host.
create trusted_host <ipaddr>
The create trusted_host command creates the trusted host. The
Switch allows specification up to four IP addresses that are allowed to
manage the Switch via in-band SNMP or TELNET based management
software. These IP addresses must be members of the Management
VLAN. If no IP addresses are specified, then there is nothing to
prevent any IP address from accessing the Switch, provided the user
knows the Username and Password.
<ipaddr>  The IP address of the trusted host.
C o m m u n i t y N a m e / S N M P v 3 U s e r N a m e
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
p r i v a t e
a u t h p r i v
50
p u b l i c