D-Link xStack DES-6500 Cli Manual page 218

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config radius add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS server communication settings:
D E S - 6 5 0 0 : 4 # c o n f i g r a d i u s a d d 1 1 0 . 4 8 . 7 4 . 1 2 1 k e y
d l i n k d e f a u l t
C o m m a n d : c o n f i g r a d i u s a d d 1 1 0 . 4 8 . 7 4 . 1 2 1 k e y d l i n k
d e f a u l t
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config radius delete
Purpose
Syntax
Description
Parameters
Restrictions
Used to add a new RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd
32> [default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
The config radius add command is used to add RADIUS servers to
the Switch.
<server_index 1-3>  Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be
entered on the Switch. The lowest index number will have a higher
authenticative priority
<server_ip>  The IP address of the RADIUS server.
key  Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
 <passwd 32>  The shared-secret key used by the RADIUS
server and the Switch. Up to 32 characters can be used.
default  Uses the default UDP port number in both the "auth_port"
and "acct_port" settings.
auth_port <udp_port_number>  The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number>  The UDP port number for accounting
requests. The default is 1813.
Only Administrator-level users can issue this command.
Used to delete a previously entered RADIUS server configuration.
config radius delete <server_index 1-3>
The config radius delete command is used to delete a previously
entered RADIUS server configuration.
<server_index 1-3>  A number identifying the current set of RADIUS
server settings delete. Up to 3 groups of RADIUS server settings can
be entered on the Switch.
Only Administrator-level users can issue this command.
214