D-Link xStack DES-6500 Cli Manual page 273

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config time zone
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure time zone settings:
DES-6500:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DES-6500:4#
config dst
Purpose
Syntax
Description
Parameters
Used to determine the time zone used in order to adjust the system
clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
This will adjust system clock settings according to the time zone. Time
zone settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour <gmt_hour 0-13> – Select the number hours different from GMT.
min <minute 0-59> – Select the number of minutes difference added
or subtracted to adjust the time zone.
Only Administrator-level users can issue this command.
Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat>| s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_week <end_week 1-4,last> | e-day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90
| 120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth
1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
DST can be enabled and configured using this command. When enabled
this will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.
disable - Disable the DST seasonal time adjustment for the Switch.
repeating - Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be
specified using a formula. For example, specify to begin DST on Saturday
during the second week of April and end DST on Sunday during the last
week of October.
annual - Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
269