D-Link xStack DES-6500 Cli Manual page 135

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config vlan add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add 4 through 8 of module 2 as tagged ports to the VLAN v1:
D E S - 6 5 0 0 : 4 # c o n f i g v l a n v 1 a d d t a g g e d 2 : 4 - 2 : 8
C o m m a n d : c o n f i g v l a n v 1 a d d t a g g e d 2 : 4 - 2 : 8
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config vlan delete
Purpose
Syntax
Description
Parameters
Used to add additional ports to a previously configured VLAN.
config vlan <vlan_name 32> {[add [ tagged | untagged | forbidden]
<portlist> | advertisement [enabled | disabled]}
This command allows the user to add ports to the port list of a
previously configured VLAN. Additional ports may be specified as
tagging, untagging, or forbidden. The default is to assign the ports as
untagging.
<vlan_name 32>  The name of the VLAN to which to add or delete
ports.
add  Specifies which ports to add. The user may also specify if the
ports are:
 tagged  Specifies the additional ports as tagged.
 untagged  Specifies the additional ports as untagged.
 forbidden  Specifies the additional ports as forbidden.
<portlist>  A range of ports to add to the VLAN. The port list is
specified by listing the lowest line card number and the beginning port
number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies line card number
1, port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all
of the ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
advertisement [enabled | disabled]  Enables or disables GVRP on the
specified VLAN.
Only Administrator-level users can issue this command.
Used to delete ports from a previously configured VLAN.
config vlan <vlan_name 32> delete <portlist>
This command is used to delete ports from the port list of a previously
configured VLAN.
<vlan_name 32>  The name of the VLAN from which to delete ports.
131