D-Link xStack DES-6500 Cli Manual page 355

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
To configure the OSPF virtual interface settings:
DES-6500:4#config ospf virtual_link 10.1.1.2 20.1.1.1
hello_interval 10
Command: config ospf virtual_link 10.1.1.2 20.1.1.1
hello_interval 10
Success.
DES-6500:4#
delete ospf virtual_link
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To delete an OSPF virtual interface from the Switch:
show ospf virtual_link
Purpose
Syntax
Description
Parameters
Used to delete an OSPF virtual interface.
delete ospf virtual_link <area_id> <neighbor_id>
This command will delete an OSPF virtual interface from the Switch.
<area_id>  A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<neighbor_id>  The OSPF router ID for the remote area. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area's Area Border Router. The router
ID of the neighbor router.
Only Administrator-level users can issue this command.
DES-6500:4#delete ospf virtual_link 10.1.12
20.1.1.1
Command: delete ospf virtual_link 10.1.12
20.1.1.1
Success.
DES-6500:4#
Used to display the current OSPF virtual interface configuration.
show ospf virtual_link {<area_id> <neighbor_id>}
This command will display the current OSPF virtual interface
configuration.
<area_id>  A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<neighbor_id>  The OSPF router ID for the remote area. This is a 32-
bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the remote area's Area Border Router. This is the router ID of
the neighbor router.
351