D-Link xStack DES-6500 Cli Manual page 318

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Command
create pim static_rp group
delete pim static_rp group
show pim static_rp
config pim rp_spt_threshold
config pim last_hop_spt_threshold
show pim rpset
show pim crp
config pim cbsr
show pim cbsr
show pim
show pim neighbor
show pim ipmroute
create pim register_checksum_include_data rp_address
delete pim register_checksum_include_data rp_address
show pim register_checksum_include_data_rp_list
Each command is listed, in detail, in the following sections.
enable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To enable PIM as previously configured on the Switch:
DES-6500:4#enable pim
Command: enable pim
Success.
DES-6500:4#
Used to enable the PIM function on the Switch.
enable pim
This command will enable PIM for the Switch. PIM settings must first be
configured for specific IP interfaces using the config pim command.
None.
Only Administrator-level users can issue this command.
Parameters
< network_address> rp <ipaddr>
<network_address>
[<value 0-65535> | infinity]
[<value 0-65535> | infinity]
[ipif <ipif_name 12> {priority [-1 | <value 0-255>]} |
hash_masklen <value 0-32> | bootstrap_period <value
1-255>]
{ipif <ipif_name 12>}
{ipif <ipif_name 12>}
{ipif <ipif_name 12> | ipaddress <ipaddr>}
<ipaddr>
<ipaddr>
314