D-Link xStack DES-6500 Cli Manual page 302

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show dhcp_relay
Parameters
Restrictions
Example usage:
To show the DHCP relay configuration:
DES-6500:4#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Enabled
DHCP Relay Agent Information Option 82 Policy: Replace
Interface Server 1
------------ --------------- ------------
System 10.58.44.6
DES-6500:4#
Example usage:
To show a single IP destination of the DHCP relay configuration:
DES-6500:4#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
Interface Server 1
------------ ------------- ------------
System 10.58.44.6
DES-6500:4#
enable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DHCP relay:
Switch, or if an IP interface name is specified, the DHCP relay configuration
for that IP interface.
ipif <ipif_name 12> The name of the IP interface for which to display the
current DHCP relay configuration.
None.
Server 2
Server 2
Used to enable the DHCP/BOOTP relay function on the switch.
enable dhcp_relay
This command is used to enable the DHCP/BOOTP relay function on the
switch.
None.
Only Administrator-level users can issue this command.
DES-6500:4#enable dhcp_relay
Command: enable dhcp_relay
: Enabled
: 2
: 23
Server 3 Server 4
------------ --------------
Server 3 Server 4
------------ --------------
298