Jumbo Frame Commands - D-Link xStack DGS-3300 User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
Certain switches can support jumbo frames (frames larger than the standard Ethernet frame size of 1518 bytes). To transmit
frames of up to 9K (and 9004 bytes tagged), the user can increase the maximum transmission unit (MTU) size from the default
of 1536 by enabling the Jumbo Frame command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable jumbo_frame
disable jumbo_frame
show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the jumbo frame function on the Switch:
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command will allow ethernet frames larger than 1536 bytes
to be processed by the Switch. The maximum size of the jumbo
frame may not exceed 9k.
None.
None.
DGS-3324SRi:4#enable jumbo_frame
Command: enable jumbo_frame
Success.
DGS-3324SRi:4#
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command will disable the jumbo frame function on the
Switch.
None.
None.
J
UMBO
354
43
F C
RAME OMMANDS