D-Link xStack DES-6500 Cli Manual page 99

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
F o r w a r d D e l a y
M a x A g e
T X H o l d C o u n t
F o r w a r d i n g B P D U
L o o p b a c k D e t e c t i o n
L B D R e c o v e r T i m e
D E S - 6 5 0 0 : 4 #
Status 3 : STP enabled for MSTP
show stp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show STP ports 1 through 9 on switch one:
D E S - 6 5 0 0 : 4 # s h o w s t p
C o m m a n d : s h o w s t p
S T P S t a t u s
S T P V e r s i o n
M a x A g e
F o r w a r d D e l a y
M a x A g e
T X H o l d C o u n t
F o r w a r d i n g B P D U
L o o p b a c k D e t e c t i o n
L B D R e c o v e r T i m e
D E S - 6 5 0 0 : 4 #
Used to display the Switch's current instance_id configuration.
show stp ports { <portlist> }
This command displays the STP Instance Settings and STP
Instance Operational Status currently implemented on the Switch.
<portlist>  Specifies a range of ports to be displayed. The port list
is specified by listing the lowest line card number and the beginning
port number on that line card, separated by a colon. Then the
highest line card number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies line card number 1, port 3. 2:4 specifies line card number
2, port 4. 1:3-2:4 specifies all of the ports between line card 1, port
3 and line card 2, port 4  in numerical order.
None.
: 1 5
: 2 0
: 3
: E n a b l e d
: E n a b l e d
: 6 0
: E n a b l e d
: M S T P
: 2 0
: 1 5
: 2 0
: 3
: E n a b l e d
: E n a b l e d
: 6 0
95