D-Link xStack DES-6500 Cli Manual page 185

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config authen server_group
Restrictions
Example usage:
To add an authentication host to server group "group_1":
D E S - 6 5 0 0 : 4 # c o n f i g a u t h e n s e r v e r _ g r o u p g r o u p _ 1 a d d
s e r v e r _ h o s t 1 0 . 1 . 1 . 1 2 1 p r o t o c o l t a c a c s +
C o m m a n d : c o n f i g a u t h e n s e r v e r _ g r o u p g r o u p _ 1 a d d
s e r v e r _ h o s t 1 0 . 1 . 1 . 1 2 1 p r o t o c o l t a c a c s +
S u c c e s s .
D E S - 6 5 0 0 : 4 #
delete authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
utilizing the TACACS+ protocol may be added to this group.

radius - Use this parameter to utilize the built-in RADIUS
server protocol on the Switch. Only server hosts utilizing
the RADIUS protocol may be added to this group.

<string 15> - Enter an alphanumeric string of up to 15
characters to define the previously created server group.
This group may add any combination of server hosts to it,
regardless of protocol.
[add | delete] – Enter the correct parameter to add or delete a server
host from a server group.
server_host <ipaddr> - Enter the IP address of the previously
configured server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are
four options:

tacacs – Use this parameter to define the protocol if the
server host is using the TACACS authentication protocol.

xtacacs – Use this parameter to define the protocol if the
server host is using the XTACACS authentication protocol.

tacacs+ – Use this parameter to define the protocol if the
server host is using the TACACS+ authentication protocol.

radius – Use this parameter to define the protocol if the
server host is using the RADIUS authentication protocol.
Only Administrator-level users can issue this command.
Used to delete a user-defined authentication server group.
delete authen server_group <string 15>
This command will delete an authentication server group.
<string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to delete.
Only Administrator-level users can issue this command.
181