xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
S u c c e s s .
D E S - 6 5 0 0 : 4 # c o n f i g s y s l o g h o s t 1 i p a d d r e s s
1 0 . 4 4 . 6 7 . 8
C o m m a n d : c o n f i g s y s l o g h o s t 1 i p a d d r e s s
1 0 . 4 4 . 6 7 . 8
S u c c e s s .
D E S - 6 5 0 0 : 4 # c o n f i g s y s l o g h o s t 1 s t a t e e n a b l e d
C o m m a n d : c o n f i g s y s l o g h o s t 1 s t a t e e n a b l e d
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config syslog host all
Purpose
Used to configure the syslog protocol to send system log data to a
remote host.
Syntax
config syslog host all [severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <udp_port_number> | state [enabled |
disabled]]
Description
The config syslog host all command is used to configure the syslog
protocol to send system log information to a remote host.
all Specifies that the command will be applied to all hosts.
Parameters
severity Severity level indicator, as described below:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
informational Specifies that informational messages will be sent to
the remote host. This corresponds to number 6 from the list above.
warning Specifies that warning messages will be sent to the remote
host. This corresponds to number 4 from the list above.
all Specifies that all of the currently supported syslog messages that
are generated by the Switch will be sent to the remote host.
facility Some of the operating system daemons and processes have
been assigned Facility values. Processes and daemons that have not
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
78