D-Link xStack DES-6500 Cli Manual page 36

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
To configure the port security:
D E S - 6 5 0 0 : 4 # c o n f i g p o r t _ s e c u r i t y p o r t s 5 : 1 - 5 : 5
a d m i n _ s t a t e e n a b l e d m a x _ l e a r n i n g _ a d d r 5
l o c k _ a d d r e s s _ m o d e D e l e t e O n R e s e t
C o m m a n d : c o n f i g p o r t _ s e c u r i t y p o r t s 5 : 1 - 5 : 5
a d m i n _ s t a t e e n a b l e d m a x _ l e a r n i n g _ a d d r 5
l o c k _ a d d r e s s _ m o d e D e l e t e O n R e s e t
S u c c e s s
D E S - 6 5 0 0 : 4 #
show port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the port security configuration:
Used to display the current port security configuration.
show port_security {ports <portlist>}
This command is used to display port security information of the Switch
ports. The information displayed includes port security admin state,
maximum number of learning address and lock mode.
ports <portlist>  Specifies a range of ports to be displayed. The port
list is specified by listing the lowest line card number and the beginning
port number on that switch, separated by a colon. Then the highest line
card number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies line card number 1,
port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all of
the ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
None.
32