D-Link xStack DES-6500 Cli Manual page 222

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show auth_diagnostics
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current authentication diagnostics for port 16:
D E S - 6 5 0 0 : 4 # s h o w a u t h _ d i a g n o s t i c s p o r t s 1 : 1 6
C o m m a n d : s h o w a u t h _ d i a g n o s t i c s p o r t s 1 : 1 6
r a d i u s A u t h S e r v e r E n t r y = = >
r a d i u s A u t h S e r v e r I n d e x : 0
r a d i u s A u t h S e r v e r A d d r e s s
0 . 0 . 0 . 0
r a d i u s A u t h C l i e n t S e r v e r P o r t N u m b e r
r a d i u s A u t h C l i e n t R o u n d T r i p T i m e
r a d i u s A u t h C l i e n t A c c e s s R e q u e s t s
r a d i u s A u t h C l i e n t A c c e s s R e t r a n s m i s s i o n s
r a d i u s A u t h C l i e n t A c c e s s A c c e p t s
r a d i u s A u t h C l i e n t A c c e s s R e j e c t s
r a d i u s A u t h C l i e n t A c c e s s C h a l l e n g e s
r a d i u s A u t h C l i e n t M a l f o r m e d A c c e s s R e s p o n s e s 0
r a d i u s A u t h C l i e n t B a d A u t h e n t i c a t o r s
r a d i u s A u t h C l i e n t P e n d i n g R e q u e s t s
r a d i u s A u t h C l i e n t T i m e o u t s
r a d i u s A u t h C l i e n t U n k n o w n T y p e s
r a d i u s A u t h C l i e n t P a c k e t s D r o p p e d
C T R L + C E S C q Q u i t S P A C E n N e x t P a g e p P r e v i o u s
P a g e r R e f r e s h
Used to display the current authentication diagnostics.
show auth_diagnostics {ports [<portlist> | all]}
The show auth_diagnostics command is used to display the current
authentication diagnostics of the Switch on a per port basis.
ports <portlist>  Specifies a range of ports. The port list is specified by
listing the lowest line card number and the beginning port number on that
line card, separated by a colon. Then the highest line card number, and
the highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by
a dash. For example, 1:3 specifies line card number 1, port 3. 2:4
specifies line card number 2, port 4. 1:3-2:4 specifies all of the ports
between line card 1, port 3 and line card 2, port 4  in numerical order.
all – Specifies that all ports will be viewed.
None.
218
0
0
0
0
0
0
0
0
0
0
0
0