D-Link xStack DES-6500 Cli Manual page 67

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
enable autoconfig
When autoconfig is enabled and the Switch is rebooted, the normal login screen will appear for a few moments while the
autoconfig request (i.e. download configuration) is initiated. The console will then display the configuration parameters as they
are loaded from the configuration file specified in the DHCP or TFTP server. This is exactly the same as using a download
configuration command. After the entire Switch configuration is loaded, the Switch will automatically "logout" the server. The
configuration settings will be saved automatically and become the active configuration.
Upon booting up the autoconfig process is initiated, the console screen will appear similar to the example below. The
configuration settings will be loaded in normal order.
Example usage:
To enable autoconfiguration on the Switch:
D E S - 6 5 0 0 : 4 # e n a b l e a u t o c o n f i g
C o m m a n d : e n a b l e a u t o c o n f i g
S u c c e s s .
D E S - 6 5 0 0 : 4 #
C o p y r i g h t ( C ) 2 0 0 4 - 2 0 0 8 D - L i n k C o r p o r a t i o n . A l l r i g h t s
D E S - 6 5 0 0 : 4 #
D E S - 6 5 0 0 : 4 #
D E S - 6 5 0 0 : 4 # d o w n l o a d c o n f i g u r a t i o n 1 0 . 4 1 . 4 4 . 4 4
c : \ c f g \ s e t t i n g . t x t
(same as: config ipif System dhcp). The DHCP server must have the TFTP
server IP address and configuration file name, and be configured to deliver
this information in the data field of the DHCP reply packet. The TFTP server
must be running and have the requested configuration file in its base directory
when the request is received from the Switch. Consult the DHCP server and
TFTP server software instructions for information on loading a configuration
file.
If the Switch is unable to complete the autoconfiguration process the
previously saved local configuration file present in Switch memory will be
loaded.
NOTE: Dual-purpose (DHCP/TFTP) server utility software may require entry of the
configuration file name and path within the user interface. Alternatively, the DHCP
software may require creating a separate ext file with the configuration file name
and path in a specific directory on the server. Consult the documentation for the
DCHP server software if you are unsure.
D E S - 6 5 0 0 C h a s s i s E t h e r n e t S w i t c h
C o m m a n d L i n e I n t e r f a c e
F i r m w a r e : B u i l d 3 . 6 0 . B 0 2
r e s e r v e d .
63