D-Link xStack DES-6500 Cli Manual page 347

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
To configure the OSPF area aggregation settings:
DES-6500:4#config ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DES-6500:4#
show ospf aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To display OSPF area aggregation settings:
DES-6500:4#show ospf aggregation
Command: show ospf aggregation
OSPF Area Aggregation Settings
Area ID Aggregated
Network Address
------------ ---------------------
10.1.1.1 10.0.0.0/8
10.1.1.1 20.2.0.0/16
Total Entries: 2
DES-6500:4#
show ospf lsdb
Purpose
Syntax
Description
Parameters
Used to display the current OSPF area aggregation settings.
show ospf aggregation {<area_id>}
This command will display the current OSPF area aggregation settings.
<area_id>  Enter this parameter to view this table by a specific OSPF
area ID.
None.
Used to display the OSPF Link State Database (LSDB).
show ospf lsdb {area_id <area_id> | advertise_router <ipaddr> |
type [rtrlink | netlink | summary | assummary | asextlink]}
This command will display the current OSPF Link State Database
(LSDB).
area_id <area_id>  A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
advertise_router <ipaddr>  The router ID of the advertising router.
type [rtrlink | netlink | summary | assummary | asextlink]  The type of
LSDB
Type
--------------
Summary
Summary
343
Advertise
-------------
Enabled
Enabled