D-Link xStack DES-6500 Cli Manual page 350

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config ospf ipif
Restrictions
Usage example:
To configure OSPF interface settings:
DES-6500:4#config ospf ipif System priority 2
hello_interval 15 metric 2 state enable
Command: config ospf ipif System priority 2
hello_interval 15 metric 2 state enable
Success.
DES-6500:4#
Interval, Authorization Type, and Authorization Key should be the same
for all routers on the same network.
dead_interval <sec 1-65535>  Allows the specification of the length of
time between the receipt of Hello packets from a neighbor router
before the selected area declares that router down. An interval
between 1 and 65535 seconds can be specified. The Dead Interval
must be evenly divisible by the Hello Interval.
metric <value 1-65535 >  The interface metric (1 to 65535). Entering
a 0 will allow automatic calculation of the metric.
authentication – Enter the type of authentication preferred. The user
may choose between:

none – Choosing this parameter will require no authentication.
simple <password 8>  Choosing this parameter will set a simple

authentication which includes a case-sensitive password of no
more than 8 characters.
md5 <key_id 1-255>  Choosing this parameter will set

authentication based on md5 encryption. A previously configured
MD5 key ID (1 to 255) is required.
metric <value 1-65535>  This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enabled | disabled] – Used to enable or disable this function.
Only Administrator-level users can issue this command.
346